AT&T SB67060 T1 Installation Guide Page 188

  • Download
  • Add to my manuals
  • Print
  • Page
    / 232
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 187
Troubleshooting 187
Synapse Installation Guide
Single-zone OHP on AUX
OUT is not working and AUX
OUT LED is solid RED.
The OHP is configured for
use, but no connector is
detected in the jack.
Verify that your paging equipment is connected to AUX
OUT. If not, connect it, or change the OHP configuration
in the WebUI if your OHP equipment is intended to be
connected to an FXS port. For background information
and configuration instructions, see “Overhead Paging
Overview” on page 22.
Single-zone OHP on AUX
OUT is not working and the
AUX OUT LED is solid GREEN
and the WebUI is configured
for paging through the AUX
OUT jack.
The ATA has detected a cable
connected to the AUX OUT
jack. There may be a problem
with your paging equipment
or its configuration.
Refer to your OHP product documentation for installation
and configuration instructions.
To isolate OHP-related problems, connect PC speakers to
the AUX OUT jack configured for paging. If the page is
broadcast through the speakers when paged, refer to the
documentation that came with your OHP.
Verify your paging equipment configuration. Check to see
if the OHP system has settings that need to be adjusted
to work with Synapse. Refer to your paging equipment
documentation or to your VAR.
Single-zone OHP on AUX OUT
is not working and the AUX
OUT LED is flashing
GREEN
.
Paging is active (a user on
the system is paging the
OHP system). There may be a
problem with the paging
equipment or its setup.
Verify your paging equipment configuration. Check to see
if the OHP system has settings that need to be adjusted
to work with Synapse. Refer to your paging equipment
documentation or to your installer.
Symptom Probable Cause Corrective Action ATA Single-Zone OHP to AUX OUT Jack
Page view 187
1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 231 232

Comments to this Manuals

No comments