AT&T SB67060 T1 Installation Guide Page 53

  • Download
  • Add to my manuals
  • Print
  • Page
    / 232
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 52
Installation 52
Synapse Installation Guide
SB67050 ATA Installation
To install the ATA:
1. After installing at least one Deskset, plug the AC plug into an electrical outlet not controlled by a wall switch and the DC
plug into the DC jack, as shown in Figure 37. Wait up to one minute until the screen lights up.
2. Plug a Cat.-5 Ethernet cable into the port marked LAN. Plug the other end of the Ethernet cable into your office LAN.
Figure 37. ATA Power, LAN, and Station Port Connections
The ATA takes about a minute to power up.
After the ATA has found the network and the Gateway, Synchronized appears on the
third line of the display, as shown in Figure 38. This is the Idle screen.
The time and date may not be correct. The time and date are set using the WebUI. See
“System Settings” on page 94.
3. Remove the plastic covers from the FXS station ports that you are using, as shown in
Figure 37.
To prevent the loss of ATA-supported services during power outages, plug the AC power plug into an
Uninterruptible Power Supply (UPS).
LAN
DC Power
FXS 2
FXS 1
Station Ports
AUX IN AUX OUT
Figure 38. ATA Synchronized
Page view 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 231 232

Comments to this Manuals

No comments