AT&T SB67060 T1 Installation Guide download pdf (Page 101)

System Configuration 100

Synapse Installation Guide

Direct Inward Dial (T1 Gateway)

When the system is set to Call Appearance mode, use the Direct Inward Dial page to assign unique telephone numbers to

specific Desksets. Callers can bypass the Call Queue, Auto Attendant, or Operator by using those telephone numbers. The T1

Gateway uses the Direct Inward Dial (DID) data from your Telephone Service Provider to automatically route incoming calls.

DID Configuration

These settings apply to Call Appearance mode only.

 To set up Direct Inward Dial numbers:

Figure 111. DID Configuration, Part 1

1. In the Navigation Menu at left, click System Settings and

then Direct Inward Dial. The page shown in Figure 111

and Figure 113 on page 102 appears.

2. Choose to Enable or Disable automatically assigning

DIDs to new extensions. When enabled, newly added

Desksets are automatically assigned the lowest available

extension number and, if available, the corresponding DID

number. If there are no available extension numbers with

corresponding DID numbers, the new extension is created

with no DID number.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 231 232

No comments

AT&T SB67060 T1 Installation Guide Page 101