AT&T SB67060 T1 Installation Guide download pdf (Page 97)

System Configuration 96

Synapse Installation Guide

Dial Plan Settings

You can set up extension numbers for the Synapse system as either three- or four-digit extension numbers in the range of 

100 to 999, or 1000 to 9999. You can also select the Prefix for the following:

 The Default Phone Extension Prefix determines the first digit to use for extension auto assignment.

 The Park Extension Prefix determines the first digit to use for parked calls (Call Appearance mode only).

 The PSTN Trunk Prefix determines the digit to dial before dialing outside calls (Call Appearance mode only).

Since two devices must be connected to the LAN before you can use the WebUI, you need to install a Deskset before setting the

Dial Plan. In this case, modify that Deskset's settings using the WebUI Extension Settings menu after you set the Dial Plan.

 To set the Dial Plan:

Figure 107. Dial Plan Settings (Call Appearance Mode)

1. In the Navigation Menu at left, click System Settings,

then Dial Plan Settings. The page shown in

Figure 107 appears.

2. Select the Number of Digits for all of your extension

numbers.

When changing an existing system from 3-digit to

4-digit extensions or from 4-digit to 3-digit

extensions, the system automatically attempts to

convert all existing extensions. This process takes

up to two minutes, depending on how many

extensions you have. All errors or extension

number discrepancies are reported on the WebUI

page. A table of all changed extension numbers

appears when the process is complete.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 231 232

No comments

AT&T SB67060 T1 Installation Guide Page 97