AT&T SB67060 T1 Installation Guide download pdf (Page 126)

System Configuration 125

Synapse Installation Guide

Multi-Zone Overhead Paging

Unlike single-zone Paging, multi-zone Paging requires user input. In a multi-zone system,

overhead speakers are grouped into zones. Each zone is assigned a number. The user pages

the zone by starting a page and then entering the zone number (the exact method may

vary depending on the third-party OHP system being used). Refer to your OHP system’s

product documentation for installation and configuration instructions.

Because the multi-zone OHP requires the OHP to signal the user to begin speaking, it must

be connected to an FXS port and will not work if connected to the AUX OUT jack.

Unlike single-zone Paging, multi-zone Paging systems cannot be included in the Synapse

paging zones described in “Paging Zones” on page 126.

A multi-zone Page will, however, automatically appear at the bottom of the list of paging

zones on the Deskset Paging Zones screen, as shown in Figure 134.

When users select overhead paging, the Overhead Page screen shown in Figure 135

appears.

Note that the third-party Paging System uses its own tones, so there is no

local Deskset paging tone accompanying this screen.

Start

Paging Zones

Quick

Dial

1. All Extensions

2. Accounts

3. Design

4. Documentation

5. Management

6. Overhead Paging

Use or to scroll then press

SELECT or press digit.

Figure 134. Paging Zones

Including Overhead Paging

EndPage

Page

Press

EndPage

when done.

Overhead Page

You may be required to enter additional

digits bef ore paging can begin.

Figure 135. Overhead Page

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 231 232

No comments

AT&T SB67060 T1 Installation Guide Page 126