Installation 63
Synapse Installation Guide
Battery Charging
After installing the battery, charge the Headset by placing it in the Headset charger as shown below. Before registration, the
Headset ON/OFF
light flashes twice every five seconds whether the Headset is charging or not. After registration, the Headset
ON/OFF light is on when the Headset is charging.
To charge the battery:
Figure 53. Insert Headset
1. Insert the Headset into the charger as shown in Figure 53.
2. Push the Headset downward until the ON/OFF
light on the Headset turns on as shown in
Figure 54.
If the Headset has not yet been registered, the
ON/OFF light flashes blue and orange.
To register the Headset, use the process
described in “Registering an Optional
Cordless Headset” in the AT&T SB67030/031
Deskset and Accessories User’s Guide at
www.telephones.att.com/
synapseguides.
Figure 54. Headset ON/OFF Light
ON/OFF
Light
Place the Headset in the charger when not in use.
Comments to this Manuals