AT&T SB67060 T1 Installation Guide download pdf (Page 58)

Installation 57

Synapse Installation Guide

Connecting a Music on Hold Source

 To install a music on hold source:

1. Use the supplied Auxiliary Audio Cable to plug a streaming audio source, such as a radio or MP3 music player, into the

ATA AUX IN jack as shown in Figure 43. If the supplied cable does not connect to your music source, use another cable

that will connect your device to the 3.5 mm AUX IN jack. This audio source must have a volume control. The volume

adjustment on the audio device should be set to obtain the preferred level of music on hold within the system.

2. Enable Music on Hold under Hold Settings in the WebUI.

For more information, see “Hold Settings and Music on Hold (Requires ATA)” in the Synapse Administrator’s Guide at

www.telephones.att.com/synapseguides.

Figure 43. ATA Music on Hold Source Installation

The ATA AUX IN jack is set up to receive headset-out audio signals. Do not connect to a “Line-Out” audio source or

to speaker outputs.

On-hold music functionality should only be used in conjunction with music specifically licensed for on-hold use.

Licensed on-hold music is available from many third-party suppliers. AT&T disclaims any liability arising from the failure

to obtain such a license.

Music on Hold

Source

ATA

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 231 232

No comments

AT&T SB67060 T1 Installation Guide Page 58