AT&T SB67060 T1 Installation Guide download pdf (Page 49)

Installation 48

Synapse Installation Guide

 To connect the Cat.-5 LAN cable to the Deskset:

 With a PC:

If there is a networked computer and no extra Ethernet wall jacks near the

Deskset, then plug the PC Ethernet cable into the Deskset so the Deskset and

PC share the same network connection.

1. Unplug the Cat.-5 Ethernet cable from your computer.

2. Plug that Cat.-5 Ethernet cable into the Network port on the back of the

Deskset, as indicated in Figure 32.

3. Plug another Cat.-5 Ethernet cable into the PC port on the Deskset.

4. Plug the other end of the second Cat.-5 Ethernet cable into your computer.

 If a GigE network is being used, a computer connected through the

Deskset will be limited to 100 Mbits/s. If you require a GigE Ethernet rate, use separate Ethernet connections for the

Deskset and the computer so that the computer can take advantage of the greater bandwidth.

 If a PC is connected to your LAN through a Deskset, any Deskset resets and power or network interruptions will disrupt

the PC’s connection to the network.

Network PC

Figure 32. Network Connections

The PC port on the Deskset is intended for connection to an end-user PC only.

 Do not use the PC port to connect to a PC with a heavy bandwidth load (such as a network server PC or a

hub, switch, or router).

 Do not use the PC port to extend the network. The end-user PC should be the final point. Do not use the PC

port to connect to other system devices.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 231 232

No comments

AT&T SB67060 T1 Installation Guide Page 49