AT&T SB67060 T1 Installation Guide Page 133

  • Download
  • Add to my manuals
  • Print
  • Page
    / 232
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 132
System Configuration 132
Synapse Installation Guide
To configure a trunk port (FXO) door phone (Line Appearance mode):
Figure 143. Enabling Door Phone Mode
1. Enable Door Phone Mode.
a. In the Navigation Menu at left, click Device
Management, then Device Log.
b. In the Device Log list, select the PSTN Gateway
that will connect to the door phone.
c. Under Line Calibration Configuration, select a
PSTN Gateway port to be the door phone port
(under Door Phone Mode) as shown in Figure 143.
d. Click Save Configuration.
2. Name the trunk that the door phone will use.
a. In the Navigation Menu at left, click Trunk Naming.
b. On the Trunk Naming page, select the trunk (PSTN
Gateway port) for which you enabled Door Phone
Mode in Step 1.
c. Give this trunk a name such asDoor orEntry” as
shown in Figure 144. Because this name appears on
SB67030/031 Deskset screens, names should be
four to six characters in length.
3. Click .
Page view 132
1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 231 232

Comments to this Manuals

No comments