AT&T SB67060 T1 Installation Guide download pdf (Page 118)

System Configuration 117

Synapse Installation Guide

 To configure the two ATA FXS ports: (Continued)

Figure 127. ATA Settings (Call Appearance mode shown)

3. For each FXS port shown in Figure 127:

 Enter the Display Name.

The Display Name is used as part of the caller

ID when an analog phone connected to the FXS

port is used for internal calls.

 Enter an Extension Number. Ensure that this

is the same extension as selected in Fax

Destination. See “Fax Configuration” on

page 119.

 [T1] Assign a Direct Inward Dialing number for

this extension using the Select DID drop-

down list. Select <Unassigned> to release a

previously assigned DID number.

 [T1] Select whether the Outgoing Caller ID

will be the DID number or the System Pilot

Number.

 To enable PLAR, select an Extension or a

Ring Group to ring when an analog device

connected to the FXS port goes off hook.

Ensure the FXS port is not assigned to fax or

overhead paging.

4. Click to save these settings or click

to return to the previous page without saving the

changes.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 231 232

No comments

AT&T SB67060 T1 Installation Guide Page 118