AT&T MERLIN LEGEND Communications System Key System Planning Forms Errata Instruction Manual Page 168

  • Download
  • Add to my manuals
  • Print
  • Page
    / 394
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 167
MERLIN LEGEND Communications System Release 5.0
System Planning
555-650-112
Issue 1
June 1997
Features
Page 4-26Group-Assigned Features
4
3. Under the Delay Ring Interval heading, do
one
of the following:
To keep the factory-set interval, check the 2 rings box.
To change the factory-set interval, check the second box and write
the number of rings (1 to 6) in the space provided.
4. On Form 7c:
a. Write the group number in the Group No. space. Start with
1 and
number the groups sequentially.
NOTE:
If a group is the coverage group for AUDIX Voice Power (the factory
setting is Group No. 30 but can be changed), write
AUDIX by the
group number and list the extensions of AUDIX Voice Power
subscribers (see Form 2a).
b. List the extension numbers of all senders in the group in the upper
block (see Form 2a).
c. List the receivers for the group in the lower block by doing one of the
following:
NOTES:
1. If you have not yet created calling groups, you must defer naming them as
receivers until later.
2. If the system includes a voice mail system, see that system’s
documentation for completing the receivers.
Designate a calling group as a receiver by checking the Calling
Group box (see Form 7d).
Designate the QCC queue as a receiver (Hybrid/PBX mode only) by
checking the QCC Queue box and/or listing the extension numbers
of all receivers (maximum of eight).
5. On each copy of Forms 4b, 4d, 5a and 5b that describes a specific
receiver:
a. Locate an available button on the Button Diagram.
b. Write
Group Cover and the coverage group number in the space
available.
Page view 167
1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 393 394

Comments to this Manuals

No comments