AT&T MDC 9000 Specifications download pdf (Page 35)

Programming Mode

Place the Programming Overlay over the dialpad of the system display phone

at extension 10 or 11—see “The Programming Overlays” earlier in this

chapter for more information.

To enter programming mode, press [

Feature

] [

]. A display similar to the

following appears:

PROGRAM EXTENSION 10

If you are programming from extension 11, “11” displays instead of “10.”

Press [

System Program

]. A display similar to the following appears:

10 Enter Extension Name

This display is for the Extension Name Display feature. When you are

entering System Programming mode, skip it by moving on to Step 4.

Press [

System Program

] again. A display similar to the following appears:

SYSTEM PROGRAM

Specify a programming procedure in one of two ways:

■

Direct Method to dial the code for that procedure. System

Programming procedures in this guide are identified by # and a

three-digit code (for example, System Date is #101). This method is

best when you are using only a few procedures during a programming

session and you know the codes.

Cycle Method to cycle through the procedures in numerical order.

Press [

Next Procedure

] and [

Prev Procedure

] to cycle forward and backward

through the programming procedures. This method is best when you

are using multiple procedures during a programming session, or if you

do not know the codes.

To exit programming mode, you can press [

Feature

] [

] or lift the handset

off-hook, then place it back in the cradle.

NOTE:

You can talk on the phone while you program. This is useful if you need to call

for support while programming. However, you must call before you enter

programming mode, and you must use the handset to talk, not the speaker and

microphone.

Changing Programming Type

When you are in programming mode, you can move between System

Programming and Centralized Telephone Programming. To change to

Centralized Telephone Programming when you are in System Programming,

press [

Central Tel Program

]. To move back to System Programming when you are in

Centralized Telephone Programming, press [

Central Tel Program

] then [

System Program

2-16 Programming

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 304 305

Comments to this Manuals

No comments

AT&T MDC 9000 Specifications Page 35

Comments to this Manuals

Related products and manuals for Telephones AT&T MDC 9000