AT&T SB35020 Specifications download pdf (Page 17)

Syn248 Installation and Configuration Guide Back to Contents

Installation 16

6. Insert a top mounting screw (not included) in one side and turn it several turns to

establish support. Repeat for the other side.

7. Tighten the screws.

Wall Mounting

You can mount the Gateway to a wall using the two mounting slots on the bottom of the

device. Ensure that the device is oriented as shown in Figure 3 to allow air to flow

vertically through the ventilation holes on each side of the device.

Figure 3. Wall Mount Orientation

To mount the Gateway to a wall:

1. Install two pan-head screws (with ¼-inch diameter head) 7 ⅞ inches (20 cm) apart.

The screw shaft diameter should be ⅛-inch (3.2 mm). Ensure you use anchors

appropriate for your mounting surface. Leave about ⅛-inch (3.2 mm) clearance

between the screw head and the wall.

2. Position the device with the mounting slot centers aligned over the mounting screws.

Carefully bring the device down onto the screws.

3. Slide the device downwards so that the screws go into the mounting slots on the

device. Ensure the device is secure.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 115 116

No comments

AT&T SB35020 Specifications Page 17