AT&T 2820 Instruction Manual Page 86
- Page / 164
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
65
6
MEMORY MODE OPERATION
■ Programming memory/bank/scan name
Each memory channel can be programmed with an alphanu-
meric channel name for easy recognition and can be indi-
cated independently by channel. Names can be a maximum
of 8 characters— see the following table for available char-
acters.
qSelect the desired memory channel to be programmed.
➥ Push [M/CALL•MW] several times to select memory
mode, then rotate the same band’s [DIAL] to select the
desired memory channel.
wPush and hold the same band’s [M/CALL•MW] for 1 sec.
to enter select memory write mode.
•“X” indicator and the memory channel number blink.
ePush [SEL](V/MHz•SCAN) (Left band’s) several times to se-
lect programming the name conditions.
“BANK” : The memory bank
“B NAME” : The bank name
(appears only when the selected
memory bank is edited into a bank)
“M NAME” : The memory name
“S NAME” : The scan name
(appears only when a scan edge
channel is selected)
• Frequency readouts disappear.
rPush [EDIT](M/CALL•MW) (Right band’s) to edit.
•“X” indicator and cursor blinks.
tRotate the same band’s [DIAL] to select the desired char-
acter.
• The selected character blinks.
• Push [Aa](TONE•DTMF) to select the character group from cap-
ital letter characters or lower case letters.
• Push [1/](M/CALL•MW)
(Right band’s) to select the character
group from numbers or symbols.
• Push [>](M/CALL•MW) (Left band’s) to move the cursor right;
push [<](V/MHz•SCAN) (Left band’s) to move the cursor left.
• Push [CLR](DUP/MONI) to clear the selected character.
• Push and hold [CLR](DUP/MONI) for 1 sec. to clear all charac-
ters after the selected character.
yRepeat steps e and t until the desired channel name is
programmed.
uPush [BACK](V/MHz•SCAN)
(Right band’s) to set the name.
iPush and hold [S.MW](M/CALL•MW)
(Right band’s) for
1 sec. to overwrite the memory channel to store the mem-
ory name.
NOTE: Only one bank name can be programmed into
each bank. Therefore, the previously programmed bank
name will be displayed when bank name indication is se-
lected. Also, the programmed bank name is assigned for
the other bank channels automatically.
DD
Available characters
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789
(Space)! ''#$%&'()*+,-
./:;<=>?@[\]^_`{|}
~
- INSTRUCTION MANUAL 1
- FOREWORD 2
- IMPORTANT 2
- EXPLICIT DEFINITIONS 2
- PRECAUTIONS 3
- SUPPLIED ACCESSORIES 4
- TABLE OF CONTENTS 5
- D Location 9
- D Using the mounting bracket 9
- QUICK REFERENCE GUIDE 10
- D Microphone connection 10
- D Controller’s attachment 12
- D Remote installation 12
- D Battery connection 14
- D DC power supply connection 15
- D Antenna installation 16
- ■ Your first contact 17
- ■ Repeater operation 19
- ■ Programming memory channels 20
- PANEL DESCRIPTION 22
- ■ Function display 24
- ■ Function display— continued 26
- ■ Function guide indications 28
- ■ Main unit 30
- ■ Microphone (HM-133*) 32
- ■ Microphone keypad 33
- (HM-154) 35
- SETTING A FREQUENCY 36
- D VFO and memory modes 37
- ■ Using the tuning dial 38
- ■ Using the [Y]/[Z] keys 38
- ■ Using the keypad 38
- ■ Tuning step selection 39
- ■ Lock functions 40
- BASIC OPERATION 41
- ■ Selecting output power 42
- ■ Operating mode selection 42
- ■ Squelch attenuator 43
- ■ Sub-band mute/busy beep 45
- ■ Monitor function 45
- ■ Single band operation 46
- ■ One-touch PTT function 47
- ■ Audio mute function 48
- ■ Band scope 48
- REPEATER OPERATION 50
- 34) is set 51
- D Subaudible tones 53
- D DTMF tones 54
- D 1750 Hz tone 54
- ■ Offset frequency 55
- ■ Digital mode operation 56
- ■ Call sign programming 56
- When sending a CQ 60
- ■ DV automatic detect 61
- ■ About D-STAR system 62
- ■ Digital repeater operation 63
- What is the area? 65
- What is the zone? 65
- ■ Received call sign 68
- One-touch reply 69
- ■ Copying the call sign 70
- •When “ALL” is selected 71
- ■ Break-in communication 72
- ■ Message operation 73
- Message Transmission 74
- RX message indication 75
- ■ Automatic reply function 76
- ■ EMR communication 77
- Low-speed data communication 78
- ■ DV voice memory 79
- ◆ Track size setting 80
- MEMORY MODE OPERATION 81
- , duplex direction, sub 83
- ■ Memory bank selection 84
- ■ Memory bank setting 85
- Available characters 86
- ■ Copying memory contents 88
- D Memory/call➪call/memory 89
- ■ Memory clearing 90
- CALL CHANNEL OPERATION 92
- ■ Programming a call channel 93
- SCAN OPERATION 94
- ■ Scan start/stop 95
- ■ Scan edges programming 96
- ■ Scan resume condition 98
- ■ Skip channel setting 99
- PRIORITY WATCH 100
- ■ Priority watch operation 101
- DTMF MEMORY ENCODER 102
- D Manual transmission 104
- ■ DTMF speed 105
- TONE SQUELCH AND POCKET BEEP 106
- D Reverse tone/DTCS squelch 107
- D Setting DTCS code 108
- ■ DTCS polarity setting 109
- ■ Tone scan 110
- Digital code setting 111
- PAGER/CODE SQUELCH 112
- Code programming 113
- ■ Pager operation 114
- ■ Code squelch 115
- MENU SCREEN OPERATION 116
- ■ Menu list 117
- ■ Items list 117
- ■ SET MODE items 120
- ■ DV SET MODE items 122
- ■ SCAN items 124
- ■ DUP/ TONE items 125
- ■ DISPLAY items 126
- ■ SOUND items 128
- ■ DV GPS items 129
- ■ PACKET items 130
- ■ GPS SET MODE items 130
- Alarm area 1 131
- Alarm area 2 131
- ■ GPS-A SET MODE items 132
- GPS-A symbol 133
- OTHER FUNCTIONS 134
- ■ All reset 135
- ■ Partial reset 135
- ■ Data cloning 136
- ■ Auto power OFF 137
- ■ Time-out timer 137
- ■ Packet operation 138
- D 1200 bps packet operation 139
- GPS/GPS-A OPERATION 142
- Sentence formatters selection 143
- GPS message programming 145
- Receiving a GPS transmission 146
- RX GPS message indication 147
- Programming GPS memory 147
- GPS alarm setting 148
- GPS memory clearing 148
- ■ GPS-A operation 149
- MAINTENANCE 150
- ■ Fuse replacement 151
- SPECIFICATIONS AND OPTIONS 153
- ■ Options 154
- ABOUT CE 156
- #02 Europe1 164
- #10 Europe2 164
Related products and manuals for Telephones AT&T 2820
Telephones AT&T BCM200 Specifications
(36 pages)
(36 pages)
Telephones AT&T Partner 34D User Manual
(9 pages)
(9 pages)
Telephones AT&T AT3111-2 User Manual
(35 pages)
(35 pages)
Telephones AT&T System 25 Owner's Manual
(30 pages)
(30 pages)
Telephones AT&T 882 User Manual
(54 pages)
(54 pages)
Telephones AT&T 927 User Manual
(239 pages)
(239 pages)
Telephones AT&T CL81211 User Manual
(72 pages)
(72 pages)
Telephones AT&T PARTNER MLS-12 Specifications
(152 pages)
(152 pages)
Telephones AT&T 7625 User Manual
(3 pages)
(3 pages)
Telephones AT&T MLC-6 Specifications
(139 pages)
(139 pages)
Telephones AT&T 1150 User Manual
(9 pages)
(9 pages)
Telephones AT&T Definity 7401 User's Guide
(28 pages)
(28 pages)
Telephones AT&T E2812B User Manual
(25 pages)
Telephones AT&T Partner 34D User Manual
(20 pages)
(20 pages)
Telephones AT&T EL51210 User Manual
(29 pages)
(29 pages)
Telephones AT&T 5630 User Manual
(12 pages)
(12 pages)
© 2020, manymanuals.com. All rights reserved. | 4.473 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals