92
12
PAGER/CODE SQUELCH
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
DD
Code programming
Your ID code MUST be programmed into code channel C0.
Up to 5 transmit codes (codes that you transmit) are pro-
grammable into code channels, C1 to C5, if required.
q Push [F•]to display the function guide.
w Push [MENU](V/MHz•SCAN)
(Right band’s) to enter MENU
screen.
e Rotate [DIAL] to select “DUP/TONE…” then push
[MAIN•BAND].
r Rotate [DIAL] to select “PGR MEMORY”, then push the
[MAIN•BAND].
t Rotate [DIAL] to select code channel C0.
• “C0” is your ID code and “C1” to “C5” are transmit codes.
•Each transceiver should have a different ID code.
y Push [MAIN•BAND] to select the pager code program-
ming condition.
u Rotate [DIAL] to select number (0–9) and push
[>](M/CALL•MW)
(Left band’s) or [<](V/MHz•SCAN) (Left
band’s) to select the digit.
i Repeat the step u to enter the desired 3-digit ID code,
then push [MAIN•BAND].
o Rotate [DIAL] to select a transmit code channel from C1 to
C5, then push the [MAIN•BAND].
!0 Enter the desired 3-digit transmit code as described in
steps u and i.
!1 Push [SKIP](V/MHz•SCAN)
(Left band’s) to set the channel
to “receive inhibit” or “receive accept” ON and OFF.
• When “receive inhibit” is set, “SKIP” appears.
• Code channel C0 cannot be set as “receive inhibit.”
• See the table for “receive accept” and “receive inhibit” details
on the previous page.
!2 Repeat steps o and !1 to set additional transmit code
channels, if desired.
!3 Push [BACK](V/MHz•SCAN)
(Right band’s) twice to return
to frequency indication.
•Receive accept/receive inhibit
➥ “Receive accept”
(no “SKIP” indication)
accepts pager calls
when the transceiver receives a signal with a code the
same as that in the code channel.
➥ “Receive inhibit”
(“SKIP” appears) ignores calls even when
the transceiver receives a code that is the same as the
code in the code channel. Transmit codes should there-
fore be programmed for “receive inhibit,” otherwise the
transceiver will not reject unnecessary calls.
Comments to this Manuals