AT&T MLC-6 Instruction Manual download pdf (Page 29)

Connecting MLS-CA24 Intercom Autodialers

One Autodialer

Power

Unit

Wall

Jack

In Out

Power

To connect one Intercom

Autodialer to a system phone: A)

Unplug the phone’s modular telephone

cord from the jack on the bottom of the

phone and the wall jack, and save the

cord for step B. Then, plug one end of

the D8W cord, supplied with the

autodialer, into the phone. Route the

other end through the groove at the

back of the autodialer and plug it into

the OUT jack. B) Route one end of the

modular telephone cord through the

groove at the back of the autodialer

and plug it into the IN jack; plug the

other end into the wall jack for

extension 10 or 11.

1

A) Connect auxiliary power.

Connect one end of the power cord,

supplied with the autodialer, to the

POWER jack on the bottom of the

autodialer, routing it through the

groove as you did in step 1; plug the

other end into the modular jack of the

power supply unit. B) Plug the power

supply into the electrical outlet.

2

3

Arrange the autodialer(s) on your

desk next to the phone. Remove the

plastic cover from each autodialer

and place a labeled button sheet on

it, and then carefully replace the

plastic cover.

NOTE. If you have an MLS-12D

system phone, install its stand to

match the height of the autodialer.

See “Assembling System Phones”

earlier in this section.

NOTE: You can wall mount an

Intercom Autodialer to work next to a

wall-mounted system phone.

Two Autodialers

Wall Jack

Power

Unit

In Out

Power

1

To wire two Intercom Autodialers to

2

A) Using the modular telephone

a system phone: A) Connect the

cord, route one end through the

phone to the first autodialer, following

groove at the back of the second

the instructions in step 1A above (the

autodialer and plug it into the IN jack;

figure at the top of this page).

plug the other end into the wall jack for

B) Using the second D8W cord,

extension 10 or 11. B) Connect

connect the two autodialers together:

auxiliary power using the instructions

plug one end of the line cord into the IN

in step 2 above (second power supply

jack on the first autodialer, and plug the

is not needed). C) Arrange the

other end into the OUT jack on the

autodialers on the desk using the

second autodialer.

instructions in step 3 above.

Installing the Hardware

2-11

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 128 129

Comments to this Manuals

No comments