AT&T MLC-6 Instruction Manual download pdf (Page 27)

Assembling System Phones

Desk Mounting (stand required for MLS-34D; optional for other system phones)

1

A) Plug one end of the handset

A) Remove the plastic cover

cord into the jack on the handset and

the other end into the small jack on the

left side of the base. If installing an

MLS-34D, go directly to step 2 (skip

1B). B) Plug one end of the phone

cord into the big jack on the bottom of

the phone. Push the cord into place

along the channel on the bottom of the

phone. If you want to raise the angle of

the phone, go to step 2 and install the

telephone stand. If not, go to step 3.

2

To install the telephone stand

(required for the MLS-34D), gently

place the phone upside down, with the

low end of the phone to your right.

Insert the tab on the narrow end of the

stand into the right slot on the bottom

of the phone. (For an MLS-34D

phone, feed the cord through the

stand and plug it in.) Then insert the

other tab into the left slot, pushing the

stand down and slightly inward until

the tab locks into place.

3

from the phone and place a labeled

button sheet on the phone so the

holes on the sheet fit over the buttons.

Carefully replace the plastic cover.

B) Slide the Quick Reference card

under the telephone.

NOTE: If you wall mount a display

phone, the display may be difficult to

read, so desk mounting is

recommended.

Wall Mounting (stand required for all system phones)

1

Reverse the plastic hook that sits in

the earpiece part of the handset cradle.

CAUTION:

Do not unscrew the bottom of the

phone. To do so will expose you

to a risk of electrical shock.

NOTE: Wall mounting instructions

apply to corded MLS-model phones

only. To wall mount an MLC-6 cordless

phone, follow the instructions in the

booklet provided with the phone.

2

To install the telephone stand,

gently place the phone upside down

with the low end of the phone to your

right. Insert the tab on the narrow end

of the stand into the left slot on the

bottom of the phone. (For an

MLS-34D phone, feed the cord

through the stand and plug it in.)

Then insert the other tab into the right

slot, pushing the stand down and

slightly inward until the tab locks into

place.

3

Insert the phone cord through

the center of the stand and plug it into

the jack on the base of the phone,

then plug the other end into the

modular wall jack. Mount the phone

on the wall jack using the screw

keyholes on the base of the stand.

For proper mounting, the wall jack

must be an AT&T 630B connecting

block. Finally, connect the handset

cord as described in “Desk

Mounting,” step 1A above, and label

the button sheet as in step 3A above.

Installing the Hardware

2-9

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 128 129

Comments to this Manuals

No comments