AT&T TL7100 User Manual download pdf (Page 26)

Getting started

Adding and registering a headset to an AT&T

DECT cordless telephone

To register a headset to an AT&T DECT cordless telephone base

You must deregister the headset from the

headset base (see page 21).

Make sure the battery is properly installed in

the headset (see page 8). The ON/OFF light

flashes twice every five seconds to indicate

the headset is not registered.

Place the headset in the headset base and

allow it to charge for at least five minutes

before beginning the registration. Leave

the headset in the headset base while

registering the headset.

On the telephone base of the cordless

phone, press and hold the

HANDSET LOCATOR button until the

IN USE light turns on (about four seconds)

and then release the button.

The headset is registered to the telephone

base automatically. It may take about 30

seconds to complete. The IN USE light

on the telephone base turns off. The

headset ON/OFF light turns blue on the

first headset registered and orange on

the second headset registered. To verify

the registration was successful, press the

ON/OFF button and check for a dial tone.

NOTE: If the registration fails, the ON/OFF light on the headset flashes twice

every five seconds. Reset the headset and try again. Remove the headset from

the headset base and press ON/OFF. Then place the headset back into the

headset base. Try the registration process again.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 67 68

No comments

AT&T TL7100 User Manual Page 26