AT&T TL7100 User Manual download pdf (Page 25)

Getting started

Adding and registering a headset to the

headset base

To register a headset to the headset base

Make sure the battery is properly installed in the

headset (see page 8). The ON/OFF light flashes

twice every five seconds to indicate the headset is

not registered.

Place the headset in the headset base and

allow it to charge for at least five minutes

before the registration.

Remove the headset from the headset base.

Press and hold the PAIR button until the

MUTE light on the headset base turns on

(about four seconds) and release the button.

Return the headset to the headset base

for registration.

It may take about 30 seconds to complete the

registration. The MUTE light on the headset

base turns off. The headset ON/OFF light turns

blue on the first headset registered and orange

on the second headset registered.

To verify the registration was successful, press

the headset ON/OFF button and check for a

dial tone.

If the registration fails, the ON/OFF light

on the headset flashes twice every five seconds. To reset the

headset, remove the headset from the headset base and try the

registration process again.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 67 68

No comments

AT&T TL7100 User Manual Page 25