User’s manualPart 2 Big button telephone 929
8Telephone operationMake a callLift the handset or press .When you hear a dial tone, dial the number you wish to call using the dial pad
9RedialThe last number dialed is stored in the redial memory. To dial that number, lift the handset or press to listen for a dia
10Handset volumeSlide HS VOL (handset volume) on the telephone base to adjust the volume of what you hear through the handset. Slide the
11Telephone memoryThis telephone can store 13 telephone numbers, each up to 16 digits. You can dial numbers stored in memory by pressing one or
12Store a pause in a memory numberPress REDIAL/PAUSE once to store a three to four second pause in the dialing sequence. Each additional press wi
13General product careTo keep your telephone working and looking good, follow these guidelines:Avoid putting it near heating appliances
14The telephone does not ring• Make sure the RINGER switch is not set to OFF.• If there are several other telephones conn e cted on
15TroubleshootingCannot store telephone numbers in memory• Make sure you are pressing the correct sequence of buttons when storing numbers (see
16Technical specificationsREN 1.5BPowerLine feed voltage 48V +/- 2VLine loop current 18mA to 100mARinger levels Off = 0dB HI = 85dBCompliance FC
17AAnswer a call 8Audio assist 10BBatteries 3, 5DDirectory card 11EEnd a call 8Erase redial 9FFlash 9HHandset tab 7Handset volume 1
© 2007 Advanced American Telephones. All rights reserved. AT&T and the AT&T logo are trademarks of AT&T Intellectual Property II, L.P. d/b
www.telephones.att.com© 2007 Advanced American Telephones. All rights reserved. AT&T and the AT&T logo are trademarks of AT&T Intellectual
Before you beginParts checklist ...2InstallationTable/desk installation ...3Wall installation ... 5Tele
2Parts checklistYour telephone contains the following items. Save your sales receipt and original packaging in the event warranty serv
3InstallationTable/desk installationInstall the desk/table bracket to the upper portion on the telephone base. Plug the tabs on the bracket i
4Set the tone/pulse switch. If you have touch tone service, set the switch to TT (tone). If you have dial pulse (rotary) service, set the switch to DP
5Wall installationInstall the wall bracket to the lower portion on the bottom of the telephone base. Plug the tabs on the bracket into the slots on th
6InstallationSet the tone/pulse switch. If you have touch tone service, set the switch to TT (tone). If you have dial pulse (rotary) service, set the
7Reverse the handset tab. This tab holds the handset when you hang up. Hold down the switchhook and slide the tab up and out of its slot. Turn the ta
Comments to this Manuals