AT&T EL52251 User Manual download pdf (Page 47)

Answering system

Answering system settings

Remote access code

To access your answering system remotely from any touch-tone telephone,

you need to enter a two-digit number (00-99). Unless you change it, the

remote access code is 19.

To change the remote access code:

Press MENU/SELECT in idle mode to enter the main menu.

Press CID or DIR to scroll to >ANSWERING SYS, then press

MENU/SELECT.

Press CID or DIR to scroll to >ANS SYS SETUP, then

press MENU/SELECT.

Press CID or DIR to scroll to >REMOTE CODE, then

press MENU/SELECT.

Press CID or DIR to select the remote access code, or use the dialing

keys to enter the correct number (00-99).

Press MENU/SELECT to save your setting. A confirmation tone sounds.

NOTE: For more details about the remote access feature, refer to Remote access on page 52.

Message alert tone

When the message alert tone is on, and there is at least one new message,

the telephone base beeps every 10 seconds. By default, the message alert

tone is set to OFF.

To change the setting:

Follow Steps 1-3 in Remote access code above.

Press CID or DIR to scroll to >MSG ALERT TONE, then

press MENU/SELECT.

Press CID or DIR to choose between >ON and >OFF.

Press MENU/SELECT to save your setting. A confirmation

tone sounds.

NOTES:

The message alert tone beeps only if all the conditions below are met:

– The answering system is on.

– The message alert tone is on.

– There are new messages.

To temporarily turn off the message alert tone, see Temporarily turn off the message alert

tone on page 46.

•

REMOTE CODE

MSG ALERT TONE

>OFF

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 82 83

No comments

AT&T EL52251 User Manual Page 47