AT&T CL82101 Technical Information download pdf (Page 4)

Battery installation and charging

Once you have installed the battery, the screen indicates the battery

status. For best performance, keep the handset in the telephone base or

charger when not in use. The battery is fully charged after 10 hours of

continuous charging.

BY 1021

BT183342/BT283342

2.4V 400mAh Ni-MH

Step 1

Plug the battery

connector securely

into the socket inside

the handset battery

compartment, matching

the color-coded label.

Insert the supplied

battery with the label

THIS SIDE UP facing up

as indicated.

Step 2

Align the cover flat

against the battery

compartment, then

slide it upwards until

it clicks into place.

NOTE: If you are on a phone call in low battery mode, you hear four short beeps

every minute.

Step 3

Charge the handset by placing it face forward in the

telephone base or charger. The CHARGE light on the

top of the handset is on during charging.

IMPORTANT INFORMATION

1. Use only the supplied rechargeable battery or replacement battery (model BT166342).

To order, visit our website at www.telephones.att.com or call

1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.

2. If you do not use the handset for a long time, disconnect and remove the battery

to prevent possible leakage.

After you install your telephone or power returns following a power outage,

the handset will prompt you to set the date and time. To skip setting the date

and time, press OFF/CANCEL.

CHARGE light

1 2 3 4 5 6 7 8 9

No comments

AT&T CL82101 Technical Information Page 4