AT&T HS8240 User Manual download pdf (Page 10)

Programming Home and Local Area Codes

Your “home area code” is the area code from which you are dialing.

Numbers called within your home area code do not require you to dial a “1”

or the area code before dialing the telephone number. “Local area codes”

are area codes that require no “1” before dialing the telephone number;

however, the area code must be dialed.

Always program your home area code, and, if you need them, your local area

codes (up to four). Programming these area codes will change how numbers

are displayed in the call history, and will allow for correct operation of the

Display Dial feature (see below).

1 Make sure the is not displayed.

2 Press U >.

3 Use the softkey to select SETUP.

4 Select DONE until the screen displays AREA CODE 1. Use the keypad

to enter your home area code.

NOTE: If you must dial the area code to complete a call in your home

area, enter “000” for AREA CODE 1.

5 Select CODE 2 to reach AREA CODE 2 (the screen displays any

current local area code stored here). Use the keypad to enter a

three-digit local area code.

6 Continue as in Step 4 for area codes 3, 4 and 5 as needed

— OR —

Select DONE to move to the next feature

— OR —

Press U to exit.

Turning Off Caller ID with Call Waiting

If you don’t have Caller ID with Call Waiting service, you can turn this feature

off (the phone comes with the feature on).

1 Make sure the is not displayed.

2 Press U >.

3 Use the softkey to select SETUP.

4 Select DONE until the screen displays CIDCW: ON.

5 Select CHANGE. The screen displays CIDCW: OFF.

6 Select DONE to move to the next feature

— OR —

Press U to exit.

FEATURE SETUP

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

AT&T HS8240 User Manual Page 10