AT&T TL7800 User Manual download pdf (Page 18)

Getting started

Make sure the battery is properly installed

in the headset (see page 6). The light on

the headset flashes slowly in red and blue

to indicate the headset is not registered.

Place the headset in the headset charger

and allow it to charge for at least one

hour before beginning registration.

Remove the headset from the charger.

On the telephone base of the cordless phone,

press and hold /HANDSET LOCATOR until

the red IN USE light turns on (about four

seconds) and then release the button.

Place the headset back to the charger.

The light flashes quickly in red and blue.

It takes about 60 seconds to complete the

registration process. The light turns red

when the headset is registered but not fully

charged, or turns blue when it is registered

and fully charged.

To verify the registration, press the button

on the headset and check for a dial tone.

If the registration fails, you hear the voice

prompt "Not registered" and the light on

the headset flashes slowly in red and blue.

To reset the headset, remove it from the

headset charger and try the registration process again.

NOTE:

The button used for registration on your cordless telephone system may

be different. Refer to your telephone user's manual for detailed information.

Adding and registering headsets

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 54 55

No comments

AT&T TL7800 User Manual Page 18