User’s manual TL7610/TL7611DECT 6.0 cordless headset
4Getting startedAvoid placing the headset base too close to:• Communication devices such as: television sets, VCRs, or other cordless telephones.• E
5Getting startedHeadset base installationOptional accessoriesThe following optional accessories are compatible with your headset and base:The TL7000 i
6Getting startedHeadset base installationInstallation optionsIMPORTANT: If you purchased model TL7611, or if you purchased a model TL7000 handset lift
7Getting startedHeadset base installationInstallation optionsDigital subscriber line (DSL)If you subscribe to high-speed Internet service (digital sub
8Getting startedHeadset base installationInstallation preparation Before installing the headset base:Remove the rear bottom piece of the headset base
9Getting startedHeadset base installationOption 1: Headset base with corded or cordless phone installation (TL7610)2. Plug one en
10Getting startedHeadset base installationOption 2: Headset base stand-alone installation (TL7610)In order to make calls, you need a telephone plugge
11Getting startedHeadset base installationOption 3: Headset base with corded phone for multiple line system or digital business system
12Getting startedHeadset base installationNo lifter mode or lifter modeThere are two answer modes available on the headset base. The current mode is i
13Getting startedON/OFFHeadset base installationAdjust lifter audioPress MODE on the headset base to change the mode if the LIFTER MODE light is not o
Congratulations on your purchase of this AT&T product.Before using this AT&T product, please read the Important safety information on pages 5
14Getting startedBattery installationInstall the battery as shown below. After installing the battery, you may be able to make and receive short calls
15Getting startedBattery chargingAfter installing the battery, charge the headset by placing it in the headset base as shown below. The headset ON/OFF
16Getting startedHeadset attachmentsOver-the-ear hookTo attach the ear hook to the headset:Remove any headset attachment connected to the headset.Inse
17Getting startedHeadset attachmentsOver-the-ear hookTo adjust the headset to wear on the left or right ear:Hold the headset in your hand. Lift the ho
18Getting startedHeadset attachmentsOver-the-ear hookTo remove the ear hook from the headset:Hold the headset with one hand and the ear hook with the
19Getting startedHeadset attachmentsOver-the-headbandTo attach the headset to the headband for wearing on the left or right ear:Remove any headset att
20Getting startedHeadset attachmentsOver-the-headbandTo remove the headset from the headband:Hold the headset with one hand and the headband ring with
21Getting startedThe neckband ring is positioned for right-ear wearing when shipped. To wear the headset on your left ear:Remove the ring from the nec
22Getting started3. Push the earpiece towards the neckband ring until it clicks into place as shown in Figure 3.4. Place the neckband arou
23Getting startedTo remove the headset from the ring of the neckband:Hold the headset with one hand and the neckband ring with the other hand. Twist a
Headset base Battery for headsetCordless headsetUser's manual Quick start guideOver-the-ear hookUser’s manual TL7610/TL7611DECT 6.0 cordless head
24OperationHeadset operationMaking a callUsing the headset base as a stand-alone product (installation option 2):In order to make calls, you need to h
25OperationHeadset operationMaking a callNOTES: For instructions on using the lifter, see the TL7000 user’s manual. Visit www.telephones.att.com to do
26OperationHeadset operationEnding a call on the headsetWhen the headset base is plugged into the telephone wall jack (installation option 1 or 2):Pre
27OperationHeadset operationTemporary ring tone silencingPress MUTE/FLASH to temporarily silence the ring tone in the headset earpiece. This silences
28OperationOptions while on callsVolume controlTo adjust the listening volume:While on a call, press the VOLUME + – keys on the side of the headset
29OperationOptions while on callsSwitching a call between handset and headset When the headset base is plugged into the telephone wall jack (installat
30OperationOptions while on callsMultiple headset/handset useHeadset(s) and handset(s) on the same phone line can join an external call in progress. T
31OperationOptions while on callsMuteThe mute function allows you to turn off the headset microphone. You can hear the caller, but the caller is not a
32OperationHeadset alert tonesThree quick beeps.VOLUME + – keys are pressed when the volume is already at its highest or lowest setting.The headset
33OperationON/OFF light statusOn Headset is charging in the headset base.Headset is trying to register to the headset base.Headset is searching for th
Headset base Battery for headsetCordless headsetTelephone line cords(4-conductor and 2-conductor)TL7610/7611 User's manualTL7610/7611 Quick start
34OperationHeadset base light statusNO LIFTER MODE On when NO LIFTER MODE is selected (default mode).Flashes quickly when there is an incoming call.Fl
35Registration and de-registrationAdding and registering headsetThe TL7610/7611 accommodates up to two cordless headsets. You can add a new headset (T
36Registration and de-registrationAdding and registering headset to headset baseTo register a headset to the headset base:Make sure the battery is pro
37Registration and de-registrationReplacing a headset You may need to de-register your headsets if:You have two registered headsets and need to replac
38Registration and de-registrationReplacing a headset To de-register all headsets and the dial pad (if applicable)4. To re-register the headset(s)
39Registration and de-registrationAdding and registering headset to telephoneTo register the headset to an AT&T DECT cordless telephone base:You m
40Maintenance and TroubleshootingMy headset doesn’t work at all.• Make sure the power cord is securely plugged in.• Make sure the battery connector
41Maintenance and TroubleshootingIf you are using LIFTER MODE, you might need to slide the LIFTER AUDIO ADJUST switch (page 13).• If the previous su
42Maintenance and TroubleshootingYour telephone may experience interference from the headset. To overcome this problem, move the headset base at least
43Maintenance and Troubleshooting• First try all the suggestions above.• Make sure you have a dial tone before dialing. The cordless headset may ta
User’s manualTL7610/TL7611DECT 6.0 cordless headset Getting startedQuick reference guide headset ...1 h
44Maintenance and TroubleshootingI want to use my headset with a different headset base.• You need to de-register (see page 37) the headset from the
45Maintenance and TroubleshootingThe batteries do not hold a charge.• Make sure that the headset battery is installed and securely plugged into the c
46Maintenance and Troubleshooting• If you subscribe to high-speed Internet service (digital subscriber line - DSL) through your telephone lines, you
47Maintenance and TroubleshootingI hear other calls while using my headset.• Disconnect the headset base from the telephone jack, and plug in a diffe
48Maintenance and Troubleshooting• Test a working phone at the phone jack. If another phone has the same problem, the problem is the phone jack, wi
49Maintenance and Troubleshooting• Other electronic products can cause interference to your cordless headset. Try installing your headset as far away
50Maintenance and TroubleshootingThe ON/OFF light on the headset is off while charging.• Make sure the power and line cords are plugged in correctly
51Maintenance and TroubleshootingCommon cure for electronic equipment.If the unit does not seem to be responding normally, try putting the cordless he
52Maintenance and TroubleshootingImportant safety informationThis symbol is to alert you to important operating or servicing instructions that may app
53Maintenance and TroubleshootingImportant safety informationReplace batteries only as described in your user’s manual. Do not burn or puncture batter
Call waiting ... 28 Switching a call between handset and headset ... 29 Multiple headset/handse
54Maintenance and TroubleshootingImportant safety informationRechargeable batteries: This product contains nickel-cadmium, nickel-metal hydride or
55Maintenance and TroubleshootingImportant safety informationTo prevent fire or shock hazard, do not expose this product to water or any type of moist
56Maintenance and TroubleshootingMaintenanceTaking care of your headsetYour cordless headset contains sophisticated electronic parts, so it must be tr
57Appendix AFCC Part 68 and ACTAThis equipment complies with Part 68 of the FCC rules and with technical requirements adopted by the Administrative Co
58Appendix AFCC Part 68 and ACTAIf this equipment is causing harm to the telephone network, the telephone company may temporarily discon
59Appendix AFCC Part 68 and ACTAIndustry CanadaOperation is subject to the following two conditions: (1) this device may not cause harmful in
60Appendix BFCC Part 15This equipment has been tested and found to comply with the requirements for a Class B digital device under P
61Appendix BFCC Part 15To ensure safety of users, the FCC has established criteria for the amount of radio frequency energy that can be safely
62Appendix CLimited warrantyThe AT&T brand is used under license - any repair, replacement or warranty service, and all questions about this produ
63Appendix CLimited warranty3. How long is the limited warranty period? The limited warranty period for the PRODUCT extends for ONE (1) YEAR
1Getting startedQuick reference guide - headsetON/OFFPress to make and/or answer a call, and to end a call.The light is on when the headset is chargin
64Appendix CLimited warrantyPRODUCT returned without valid proof of purchase (see item 6 below); -or-Charges for installation or setup, adjustment of
65Appendix CLimited warranty7. Other limitations This warranty is the complete and exclusive agreement between you and the manufacturer of this AT&am
66Appendix COperating rangeThis cordless headset operates within the maximum power allowed by the Federal Communications Commission (FCC). Even so, th
67IndexAAC adapter, 9-11, 53, 66Adjust lifter audio, 13Alert tones, 32Answering calls, 25Auto off, 26BBattery charging, 15Battery installation, 14CCal
68IndexIndexSSafety information, 52-55Speaking volume, 28Switching a call, 29TTechnical specifications, 66 Temporary ring tone silencing, 27Trouble
www.telephones.att.com© 2008 Advanced American Telephones. All rights reserved. AT&T and the AT&T logo are trademarks of AT&T Intellectual
2Getting startedQuick reference guide - headset baseCharging cradleInsert the headset here for charging.PAIRPress to register or de-register a headset
3Getting startedVOLUME Press the volume keys on the side of the headset base to adjust the speaking volume when on a call. MODEPress to choose bet
Comments to this Manuals